48
7. Operation (continued)
7-1-3 Soldering Conditions
Solder Feed Parameter Setting Screen
(1) Soldering Conditions
(top screen)
Solder feed programs are created in the Solder Feed Parameter Setting
Screen.
A maximum of 250 solder feed programs can be set.
(2) Soldering Feed Program
Solder feed program numbers. A single vertical column is a single program.
(3) Temperature setting
Input the temperature setting. (Settable range: 50 – 500°C)
(4)
Feed length, feed speed,
back feed length,
back feed speed,
heat time
These are the solder feed settings. The settable range for each item are
as shown in the table below.
For primary soldering, the settings are for the start point position. For both
secondary and tertiary soldering, the settings are for the end point position.
Setting item
Range
*1
Solder feed length
0.1 – 99.9 mm
Solder feed speed
0.1 – 99.9 mm/s
Solder back feed length
0 – 20.0 mm
Solder back feed speed
0 – 99.9 mm
Heat time
0.1 – 9.9 sec
*1 For secondary and tertiary soldering, all values can be set starting from 0.
(5) Solder Feed
Button for manually feeding solder. When tapped, it will be set to on
and solder will be fed. Tapping it again will set it to off. (Solder feeding,
solder retraction, and solder feed speed settings can also be performed
from the top screen.)
(6) Solder Back Feed
Button for manually retracting solder. When tapped, it will be set to on
and solder will be retracted. Tapping it again will set it to off. (Solder
feeding, solder retraction, and solder feed speed settings can also be
performed from the top screen.)
(7) Test Operation
The program for the soldering conditions number for the selected
column will be run.
(8) C:
P:
Copies the soldering conditions in the selected column.
Pastes the copied soldering conditions into the selected column.
(9)
/ :
/ :
Moves to the previous or next soldering conditions page (1 page =
10 columns)
To switch between pages (columns 1 – 10 columns 11 – 20), tap
or .
Selects the previous or next column of conditions.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(9)
(8)
