Haklift Oy
Asessorinkatu 3-7
20780 Kaarina, Finland
Tel. +358 2 511 5511
sales@haklift.com
www.haklift.com
Lifting Solutions Group
Axel Johnson International
This is a universal user manual for multiple HAVA hand pallet truck models. Specifications vary by
model. The information in this guide is based on data available at the time of printing. The manufacturer
reserves the right to make changes to its own products without notice. Please use common sense and
caution with the product/model in question and consult the manufacturer if necessary.
Note:
1. This hand pallet truck shall be used and maintained
according to the manufacturer’s requirements.
2. To ensure safety, the hand pallet truck shall not be modified or have attachments fitted.
3. When the cargo weight exceeds 2500 kg (allowed for specific models), please operate the truck by
two persons together for labor saving.
4. Model HAVA2012SS: Side-shift function will activate when the fork height is over 180 mm
– turn and
lock the handle to 90 degrees. Note! Hand pallet truck’s capacity is only 1500 kg when the side-shift
function is activated
– please refer to the product markings.
1
.
Applicable range
1.1 Hand pallet truck is a low lift transportation tool which is limited to move palletized cargo. This kind of pallet
truck possesses the features of stable lifting, easy operation, safety and reliability etc.
1.2 The working place must be non-slip, hard, clean and flat ground/platform without holes or obstacles.
1.3 The ambient lighting should be sufficient to enable safe working.
2. Main parameters (depending on the model)
Capacity (kg)
1500/2000/2500/3500/5000
Fork length (mm)
600/800/1150/1500/2000/2500
Height fork lowered (mm)
55/85
Max. lifting height (mm)
150/200
Steering wheel diameter
Ф (mm)
200/180/160/150
Fork wheel diameter
Ф (mm)
85/80/75/70/60
3. Assembly of the hand pallet truck
Assembly must be conducted by a competent person. Before assembly, verify that the spring safety pin (7) is
properly in place. The safety pin should rest well in both holes located on each side of the pump housing and
hold the spring assy.
3.1 See fig. 1. Pull out the coupling pin (1).
3.2 Insert the handle (3) to place A (take care that it will be in the right direction). Couple the handle (3) and
the pump body (5) with the coupling pin (1).
3.3 Set the spring pin (2) (delivered separately) into the designated hole at the end of the coupling pin (1) and
fix it with a hammer. The coupling pin must have spring pins at both ends. If both spring pins are delivered
separately, then also both should be fixed on each end of the coupling pin. Take care that the coupling pin is
mounted into the correct position (middle hole is facing towards the handle inner chain, so it can be threaded
through smoothly).
3.4 See fig. 2. Put the chain (4) of the handle through the middle hole of the coupling pin (1).
3.5 Take the screw nut which is at the end of the chain (4) and hitch it to the groove of the lever board (6). See
fig. 2 and fig. 4.
3.6 See fig. 3. Turn the handle to level position and pull out the spring safety pin (7).
