Haklift Oy
Asessorinkatu 3-7
20780 Kaarina, Finland
Tel. +358 2 511 5511
sales@haklift.com
www.haklift.com
Lifting Solutions Group
Axel Johnson International
INSTALLATION
•
Eyebolts/nuts should only be fitted by a trained person.
•
The depth of the threaded hole must be minimum: 1*d for steel, 1,25*d for cast iron, 2*d for aluminum
alloys, 2,5*d for aluminum magnesium alloys.
•
The threaded hole must be perpendicular to the surface.
•
Make sure that the surface of the mother screw is suitable for the planarity and dimension in order to
guarantee touching of all the surface of the eyebolt/nut and that it adheres suitably. The eyebolt/nut
cannot be used with parts of a tilting surface.
•
To install the eyebolt/nut simply manually lock the screw/nut with a suitable tool without the aid of
extension leads which could preload the screw with excessive locking (do not exceed locking specified
in the chart). To disassemble, unscrew.
•
Lock the eyebolt/nut until it fits completely onto the surface.
NOT ALLOWED
•
Do not apply lateral load (as shown in the pictures).
•
Do not use eyebolts/nuts in acid high corrosion chemical substance environment and/or in an explosive
atmosphere.
•
Do not use in environment with a temperature higher than 200 °C or lower than -40 °C. For
temperatures outside of this range, contact Haklift Oy for guidance.
•
Do not exceed the WLL marked on the product.
•
Do not use for operations which defer from the ones that are foreseen.
•
Do not use locking screws which are larger than the ones specified to assemble the lifting eye.
•
Do not use to lift people.
•
Do not stand under an overhanging load whilst it is being operated.
•
Do not stand in dangerous areas during use (dangerous areas mean areas which are deemed risky
due to falling of load during movement with accessories).
•
If changes, repairs and/or treatments are made to the product, the terms of the guarantee are no
longer applicable and the manufacturer declines all liability. Under NO circumstances should bent
eyebolts/nuts be straightened.
STORAGE
•
Product shall be stored cleaned, dried and protected from corrosion.
