Haklift Oy
Asessorinkatu 3-7
20780 Kaarina, Finland
Tel. +358 2 511 5511
sales@haklift.com
www.haklift.com
Lifting Solutions Group
Axel Johnson International
Taking all necessary precautions, take the load with the jack (i.e. jack the load up slightly) and ensuring the
handle is in the FULLY UPRIGHT position,
trip the Reversing Latch (17) so that it is in the “DOWN” position,
i.e. the indentation on the Latch becomes disengaged from the notch on the Reversing Switch (see fig. 2).
Keeping a firm grip on the handle, pump it as you would for “raising a load”.
REVERSING LATCH
To raise a load
To lower a load
Figure 1.
Figure 2.
MAINTENANCE & STORAGE
Keep the product clean and store it in a safe place protected against mechanical impacts and corrosion.
Relevant moving parts should be lubricated periodically (refer to ”LUBE” markings in the exploded view). On
a regular basis (at least once a year; more frequent if required by working conditions) a thorough inspection of
the product should be conducted and documented. Maintenance and inspections are to be performed by a
competent person.
PART LIST
1. Top Clamp-Clevis Bolt
2. Top Clamp-Clevis
3. Steel Standard (Bar)
4. Steel Handle W/Cotter Pin
5. Handle Socket
6. Pin
7. Hex Bolt
8. Connecting Rod
9. Small Runner
10. Screw Bolt
11. Base
12. Climbing Pin Spring (2 required)
13. Climbing Pin (2 required)
14. Cross Pin (2 required)
15. Reversing Switch Cam Bar and Spring
16. Cap Screw W/Washer
17. Reversing Latch
18. Reversing Switch Spring
19. Large Runner
20. Running Gear (assembled)
