One more fusebox is located on the
left of the battery. This box holds the
following fuses, starting from the rear
end:
F 41 50 Amps fuse
F 42 50 Amps fuse
F 43 50 Amps fuse for engine pre-
glow relay K
Battery
The 12 volts / 74 Ah (low mainte-
nance) battery is located on top of the
LH rear wheel housing.
Note:
never attempt to run engine
unless battery is connected. Never use
a battery charger to sustain cranking.
Before commencing work on the
electric system, disconnect ground
cable of the battery. Always disconnect
battery for charging or when doing
electrowelding on the machine.
Note :
provide for disposal of used
batteries in accordance with the appli-
cable regulations.
Wheels
The Hako-Citymaster 1800 TDI uses
195 R14 C 106 P pneumatic tires as a
standard option. Other dimensions
are available, e.g. to reduce specific
ground pressure.
F 11 = 15 Amps, windshield wiper
and washer, horn, pulse light
F 12 = 10 Amps, directional flasher
F 13 = 10 Amps, hi-beam, LH
F 14 = 10 Amps, hi-beam, RH
F 15 = 10 Amps, headlight, LH
F 16 = 10 amps, headlight, RH
F 17 = 10A, no. 1 water pump,
lift/lower hopper
F 18 = 15 Amps, heater fan, A/C/fan
F 19 = 10 Amps, searchlight
(optional)
F 20 = 10 Amps, #2 water pump
(optional)
F 21 = 5 Amps, camera (optional)
F 22 = 10 Amps, hot mirror, radio
F 23 = 15 Amps, accessory plug
connector, radio, continuous
positive
F24 = 15A switchover working and
transport ride
F25 = 10A starting lock
F26 = 10A compressor, driver's seat
F27 = 7.5A rear fog lamp (L-H stee
ring version only)
F28 = 5A control device Diesel injec
tion system
F29 = 10A control device Diesel
injection system
F30 = 30A control device Diesel
injection system
Note:
never direct water jet against
electric or electronic components such
as solenoid valves, plug con-nectors
etc.
69
Wheelchange
For changing a wheel, the Hako-
Citymaster 1800 TDI has to be jacked.
Attaching points are located on both
sides in front of the rear wheel and
behind the front wheel. Wheels are
secured with 5 ea. attaching nuts
(spanner size 19). Torque nuts to 130
Nm. Check torque after first 10 hours
and thereafter every 150 hours.
Hauling
When hauling the Hako-Citymaster
1800 TDI on a truck, close parking
brake and secure machine with straps.
Eyebolts are located on both sides
and at the front end (1 in center). If the
machine is hauled without the swee-
ping attachment installed, secure it by
its forward triangular mount.
Lubrication scheme
All points stipulated on page 70/71
(lubrication scheme) have to be
serviced with grease after every 75
hours of operation, the rollers weekly.
