9
Safety information
switch. Function of this contact
switch must not be bypassed!
• The seat contact switch will con-
trolled electronocally. Any manipula-
tion to result in automatically
blocking of the machine.
• Disengage all drive systems before
switch-on the machine.
• The machine may be started, run
and stopped by a person seated on-
ly.
• Never let the machine run in indoor
areas! Intoxication hazard!
• Provide for sufficient ventilation
when sweeping indoors (dust and
combustion gas).
Intoxication hazard!
• Always adapt the driving speed to
the ambient conditions and the load-
ing state.
Compared to four-wheeled vehicles,
driving stability of three-wheeled ve-
hicles is reduced, therefor:
Abrupt steering manoeuvres at high-
er speed or negotiating curves at
high speed may cause tipping of the
articulated vehicle.
Do not turn at slopes but on level
ground only
Ride up- and downhill straight.
Avoid taking sudden curves when
riding up- or downhill or across to the
slope.
In slope there is tilting danger.
• The machine may be used only for
operation on areas with a maximum
inclination of up to 16 %.
• Do not exceed the admissible total
weight and the admissible axle load
limits. Check the dirt hopper filling
level frequently.
• Before lifting or lowering the dirt hop-
per make sure that no persons, ani-
mals or other obstacle are in the area
of operation.
• Pinching and shearing hazard.
Provide for required safe distance
before lifting or lowering the dirt hop-
per.
• It’s only allowed to lift up the dirt hop-
per in immediately nearness of the
container.
Emtying the dirt hopper on level and
solid ground.
• Do not sweeping when the dirt hop-
per is lifted.
• By emtying the dirt hopper pay atten-
tion to bystanders.
• Proceed to filter shaking only if the
dirt hopper is in closed position.
• Pay attention to hot parts for exam-
ple cooling water, tubes of the ex-
haust etc..
1.4
Maintenance instructions
• The daily and weekly maintenance
and repair task must be performed
by a qualified operator. For any
maintenance and repair work be-
yond please contact your local Hako
service centre.
• Observe the maintenance activities
and intervals set out in the instruc-
tion manual.
• Maintenance and repair work may
be carried out only by means of ap-
propriate tools.
• Have the machine checked for safe
condition in the sense of the Acci-
dent Prevention Regulation by an
expert at regular intervals (recom-
mendation: at least once yearly) as
well as after modifications or repair.
• Spare parts have to equal the techni-
cal requirements as specified by the
manufacturer! Genuine spare parts
guarantee compliance with these re-
quirements.
• Use of other than the sweeper rollers
and side brooms approved by the
