06-1491-00-12.fm
117
Attachments and Options
6 Attachments and Options
Safety instructions for attachments
Safety instructions for ballast
Danger
•
Danger to life in the danger area of the vehicle! Special caution is required under the raised tipper,
in the area of the front and rear attachment and in the area of the trailer.
•
Risk of injury! Put the attachment into service only if all protective devices are attached and in
protection position.
•
Risk of injury! Make sure that the attachments are suitable for the set oil volume. An oil volume set
too high can lead to injuries due to a defect of the attachment!
•
Risk of injury! High-pressure hoses, fittings and couplings are important for equipment safety. Use
only high-pressure hoses, fittings and couplings recommended by the manufacturer.
•
Risk of accident! When connecting attachments to the hydraulic system, ensure that the hydraulic
hoses are connected correctly. Swapping the connection can lead to reverse functioning of the
attachment, e.g. movement to the right rather than the left.
•
Risk of accident! Front attachments not correctly fastened to the front tool carrier can drop down
while driving. Always secure the front attachment with the locking devices.
•
Risk of accident! You must consult Hako before attaching other attachments not approved by
Hako! Check in the individual case that the relevant axial loads and total weights are complied
with.
•
Risk of accident! Handling, steering and braking as well as stability are influenced by attachments,
trailers and the vehicle payload (e.g. full dirt hopper). For this reason, pay attention to adequate
steering and braking capability as well as stability.
•
Risk of accident! In Germany, if attachments extend beyond the outer lighting equipment of the
vehicle or if the maximum distances of the outer lighting equipment specified according to StVZO
are exceeded, the lighting equipment of the vehicle must be repeated (see Merkblatt StVZO § 30,
explanations 11 and 12).
Danger
•
Risk of accident! When attaching other attachments not approved by Hako, check in the individual
case whether the relevant axle loads and total weights are complied with!
•
Risk of accident! The front axle of the working machine must always be loaded with at least 25 %
of the empty weight and the rear axle with at least 37 % of the empty weight of the working
machine.
•
Risk of accident! The attachment of front and rear attachments must not lead to exceeding the
permissible total weight, the permissible axle load and the tyre load capacity of the working
machine!
Warning
•
Make sure before purchasing the attachment that these requirements are fulfilled by weighing the
working machine attachment combination!
Summary of Contents for Citymaster 1600
