18
01-1491-00-12.fm
Safety Instructions
Installation of electrical devices
•
The vehicle is equipped with electronic components and parts whose function can be influenced by electro-
magnetic emissions of other devices. Such influence can lead to danger to persons and safety-relevant
functions if the following safety instructions are not complied with:
•
If electrical and electronic devices and/or components, which also are connected to the vehicle electrical
system, are installed subsequently in the vehicle, the user must examine in his own responsibility whether the
installation causes interference to the vehicle electronics or to other components, a renewed acceptance test
may be necessary.
•
Above all it must be ensured that the subsequently installed electrical and electronic components comply with
the EMC Directive 2004/108/EC in the relevant valid edition and bear the CE marking or an E1 approval is
available.
•
In addition, the following requirements especially must be fulfilled for the subsequent installation of mobile
communication systems (e.g. radio, telephone):
•
Only devices with approval according to the valid national regulations (e.g. BZT approval in the Federal
Republic of Germany) may be installed.
•
The device must be installed permanently.
•
Operation of portable or mobile devices inside the vehicle is permitted only through a connection to a perma-
nently installed outside antenna.
•
The transmitter must be installed in a separate location from the vehicle electronics.
•
When installing the antenna, pay attention to correct installation with good ground connection between
antenna and vehicle ground.
1.7
Environmental protection instructions
•
Adequate knowledge is required for the safe handling of substances which could represent a risk to health and
the environment.
•
Observe the applicable laws and local regulations when disposing of detergents.
•
During maintenance work and repairs, operating substances and filters have to be collected in suitable
containers and properly disposed of observing the applicable laws and local regulations.
•
Leaked oil, diesel fuel and lubricants etc. must not enter into the soil. Otherwise this would create a serious risk
of groundwater contamination.
•
Any contamination from leakages has to be cleared up without delay and disposed of properly. Used filters
usually have to be disposed of as special waste (e.g. fuel filters) depending on the filtered substance.
•
Ensure safe and environment-conserving disposal of operating and auxiliary materials. Take up escaping or
spilled operating materials in suitable containers and dispose of them in an environmentally friendly manner.
•
Used batteries with the recycling symbol contain reusable commodities. In accordance with the symbol
showing the crossed-out garbage bin, these batteries must not be disposed of in the domestic waste. Return
and recycling have to be arranged with the authorised Hako dealer as required in § 6 and § 8 of the German
battery law (BattG)!
Summary of Contents for Citymaster 1600
