03-1481-00-00.fm
111
Operation
Starting the vehicle
Observe the Safety instructions – Starting the vehicle and moving off, see
page 110.
1. Insert ignition key into the ignition switch
.
2. Turn the ignition key to position "I".
•
The warning lights
light up.
•
The warning light
lights up when parking brake
is
applied.
•
The telltale
lights up when the attachment is raised or not
fully lowered.
3. At low temperatures:
•
The engine is preheated until the telltale
goes out. The
engine must be started immediately after the telltale
has
gone out.
4. Do not actuate the accelerator pedal
during the starting
procedure.
5. Turn the ignition key to position "II" and hold it in this position until the
engine starts.
6. Release the ignition key
.
0
Fig. 79:
P
I
II
Note
The starter cannot be actuated when the engine is already
running (start repeat lock). Do not run the starter for more
than 10 seconds. Wait for about 1 minute to let the battery
recover before trying again.
Note
The engine can only be started when battery master switch
(option) is switched on, the driving switch is in the neutral
position and accelerator pedal is not depressed.
Attention
Never let the vehicle roll when the diesel engine is not run-
ning. In this case,
•
there is no power steering through the diesel engine.
•
there is no brake servo through the diesel engine.
•
hydraulic components of the hydrostatic drive may be
damaged.
For information on recovering the vehicle in case of a break-
down, see see page 119.
Summary of Contents for Citymaster 2200
Page 35: ...02 1481 00 00 fm 35 Operation Fig 3 34 31 29 32 33 34 35 36 37 30...
Page 39: ...02 1481 00 00 fm 39 Operation Fig 5 73 74 71 72 72 71 74 75 76 82 83 84 77 78 79 81...
Page 43: ...02 1481 00 00 fm 43 Operation Fig 7 114 116 117 118 119 120 115 113 112...
Page 236: ...236 05 1481 00 00 fm Maintenance and servicing...
