03-1481-00-00.fm
151
Operation
3.4.10 High-pressure cleaner (option)
Observe the Safety instructions – Vacuum sweeping system,
see page 130.
Check the following before starting up the high-pressure cleaner:
•
Top up fresh water tank, see page 141
•
Check the fresh water filter, see page 154
1. Start the vehicle, drive to the work site and hold it with the parking
brake.
2. Take the spray lance
and the pressure hose
out of the
toolbox
Fig. 125-B
and connect them to the quick coupler
.
3. Start the vehicle, see page 111. Set the changeover valve
Fig. 125-D
to the high-pressure cleaner position
Fig. 125-E
.
4. Aim the spray lance at the surface to be cleaned and switch on the
water jet by pressing the lever
. Set the desired working
pressure with the pressure controller
.
5. After cleaning, set the changeover valve back to the suction fan posi-
tion.
Danger
The jet of the high-pressure cleaner must not be directed to
persons. There is a risk of injury! Do not use steam cleaners
and high-pressure cleaners for cleaning electrical/electronic
components and the engine compartment!
Fig. 125:
C
D
F
E
A
G
B
Summary of Contents for Citymaster 2200
Page 35: ...02 1481 00 00 fm 35 Operation Fig 3 34 31 29 32 33 34 35 36 37 30...
Page 39: ...02 1481 00 00 fm 39 Operation Fig 5 73 74 71 72 72 71 74 75 76 82 83 84 77 78 79 81...
Page 43: ...02 1481 00 00 fm 43 Operation Fig 7 114 116 117 118 119 120 115 113 112...
Page 236: ...236 05 1481 00 00 fm Maintenance and servicing...
