05-1481-00-00.fm
209
Maintenance and servicing
5.15.2 Changing wheels
Observe the Safety instructions – Wheels and tyres, see page 208.
Removing the wheel
1. Place the vehicle on a level surface and secure it with the parking
brake. Switch the engine off and pull out the ignition key.
2. Secure the vehicle by placing a wheel chock underneath the diagonally
opposite wheel.
3. Remove the wheel bolt caps
and loosen the wheel bolts (size 24)
slightly.
4. Place the jack (hydraulic or mechanical version) underneath the jacking
point.
5. Lift the vehicle until the wheel to be changed is off the ground.
6. Loosen the wheel bolts fully and remove the wheel from the axle.
The jacking points
for jack or lifting platform at the carrier
system:
•
front left
•
rear left
•
front right
•
rear right
Alternative jacking points of the jack underneath the axle tubes
.
Attention
When lifting the entire vehicle using a lifting platform and the
four jacking points
, make sure the weight of the
vehicle is distributed evenly. Otherwise, there is a risk of the
vehicle tipping from the jacking points!
Fig. 165:
A
B
Summary of Contents for Citymaster 2200
Page 35: ...02 1481 00 00 fm 35 Operation Fig 3 34 31 29 32 33 34 35 36 37 30...
Page 39: ...02 1481 00 00 fm 39 Operation Fig 5 73 74 71 72 72 71 74 75 76 82 83 84 77 78 79 81...
Page 43: ...02 1481 00 00 fm 43 Operation Fig 7 114 116 117 118 119 120 115 113 112...
Page 236: ...236 05 1481 00 00 fm Maintenance and servicing...