05-1481-00-00.fm
225
Maintenance and servicing
5.18.4 Checking the sweeping level (3-brush system)
Observe the Safety instructions – Vacuum sweeping system,
see page 222.
Check the sweeping level
Fig. 183-A and B
for the pulled brushes at
regular intervals. Maintenance intervals according to maintenance plan,
see page 167.
The sweeping level
Fig. 183-A and B
for the pulled brushes is adjusted in
the factory with the screws
Fig. 182-A, B and C
.
The sweeping level
Fig. 183-C
for the 3rd brush is adjusted in the factory
with the four screws
.
1. Raise the sweeping unit with the joysticks
.
2. Drive over a level surface covered with dust or chalk.
3. Lower the sweeping unit and let the brushes turn for a short time.
4. With correctly adjusted sweeping level, the following pattern must result
in driving direction:
•
Pulled brushes:
• The left rotating brush
from 10 a.m. to 4 p.m.
• The right rotating brush
Fig. 183-B
from 8 a.m. to 2 p.m.
•
3rd brush
:
• from 10 a.m. to 4 p.m.
Fig. 182:
C
A
B
Fig. 183:
D
A
B
C
Summary of Contents for Citymaster 2200
Page 35: ...02 1481 00 00 fm 35 Operation Fig 3 34 31 29 32 33 34 35 36 37 30...
Page 39: ...02 1481 00 00 fm 39 Operation Fig 5 73 74 71 72 72 71 74 75 76 82 83 84 77 78 79 81...
Page 43: ...02 1481 00 00 fm 43 Operation Fig 7 114 116 117 118 119 120 115 113 112...
Page 236: ...236 05 1481 00 00 fm Maintenance and servicing...
