168
06-147015-00-00.fm
Attachments and Options
Setting the fixed engine speed
The fixed engine speed is set with the switch
. Set the speed
according to the requirements.
The speed must be set so that a centrifuging effect is achieved.
Starting sweeping
The accelerator pedal
is used for continuously changing the
speed for driving forwards.
The accelerator pedal
is used for continuously changing the
speed for reversing.
Push the accelerator pedal down slowly until the vehicle starts, the speed
is increased further by pressing on the pedal.
Slowing down or braking the vehicle: Slowly reduce the pressure on the
accelerator pedal, the vehicle slows down or stops.
The vehicle speed in the:
•
transport mode is 0 to 25 km/h,
•
work mode 15/20/25 km/h according to selected engine speed.
Setting down the front sweeping machine
Set the front sweeping machine so that the bristles of the sweeping roller
do not touch the ground.
1. Loosen the support
Fig. 182-A
from the rear holder
of the
front sweeping machine by removing the bolt and split-pin.
2. Insert the support in the front holder
.
3. Secure with bolt and split pin when the required supporting height is
reached.
Fig. 180:
Stage
rpm
Use
1 – ECO
1900
At low load
2 – Standard 2250
For medium load
3 – Maximum 2630
For high load
Fig. 181:
Fig. 182:
A
C
B
Summary of Contents for Citymaster 650
