06-147015-00-00.fm
169
Attachments and Options
6.3.5
Technical data
6.3.6
Maintenance
Maintenance plan
Maintenance work
Changing the sweeping roller
1. Place the vehicle on a level surface and hold it with the parking brake.
Raise the front sweeping machine with the joystick
. Switch
the engine off and pull out the ignition key.
2. The sweeping rollers are fastened to the support tube
with
, washer and angle plate
Fig. 183-C
. Loosen the
screw and take everything off.
3. Fit a new sweeping roller with screw, washer and angle plate.
You must readjust the sweeping level after changing the sweeping rollers.
Checking the sweeping level
Check the sweeping rollers daily. Change worn sweeping rollers.
1. Place the vehicle on a level surface and hold it with the parking brake.
Raise the front sweeping machine with the joystick
2. Remove the split-pin
from the bolt of the wheel fork and
withdraw the supporting wheels
downwards.
3. Adjust the sweeping level with the washers
on both support-
ing wheels. For optimum sweeping effect the bristles should press over
the ground approx. 20 cm.
4. Reattach the supporting wheels and secure them with split-pins.
5. Check the sweeping level on dust and chalk.
Front sweeping machine
Unit
Length
mm
900
Width
mm
1300/1500
Height
mm
673
Sweeping width
mm
1300/1500
Weight
kg
109
Sweeping roller diameter
mm
420
Daily
•
Checking wear and damage to the front sweeping machine
Weekly
•
Checking lubrication points
Fig. 183:
A
B
C
Fig. 184:
A
B
C
Summary of Contents for Citymaster 650
