10
Fleet-Recorder Scrubmaster B115 R
2.2
Installing the
Fleet-Recorder B115 R
Caution
Prior to installation, place the
machine on a level surface, se-
cure it against rolling away and
disconnect the battery plug!
Make all the electrical connec-
tions according to the circuit
diagram of the respective
machine variant.
2.2.1
Installing the I-Button-Reader
1. Disassemble the control panel on
the left-hand side (Fig. 7/1).
2. Cut into the film in the area of the top
left hole on the rear of the control
panel (Fig. 7/2).
3. Install the I-Button-Reader.
4. Connect the plug of the
I-Button-Reader to the 4-pole plug
B20/X1 of the W78 cable loom
(Fig. 7/3).
5. Attach the cable end of the
I-Button-Reader to the available
cable loom using cable ties.
6. Route the W78 cable loom on the left
of the steering column downwards.
7. Re-install the control panel.
Fig. 7
1
2
3
4
