12
Fleet-Recorder Scrubmaster B115 R
2.2.3
Installing the antenna
Prior to installing the antenna, remove
the batteries.
Caution
Only use suitable lifting
equipment to remove/insert
batteries!
1. Install the plate at the rear wall of the
seat shell using two sheet-metal
screws according to the sketch
(Fig. 9/1).
2. Clean the adhesive surface and use
the sticker to fix the antenna to the
3. Guide the antenna cable through the
hole in the centre of the seal shell
(Fig. 9/3).
4. Route the antenna cable along the
seat contact switch cable (Fig. 9/4).
5. Route the antenna cable at the
bottom of the battery compartment
through the available cable ties into
the electronics compartment
(Fig. 9/5).
6. Use cable ties to fix the antenna
cable along the route.
Fig. 9
3
4
5
1
2
