16
Starting Up
2.3
Prior to starting up for the
first time
The following work must be completed
before starting the vehicle up for the
first time:
2.3.1
Installing brushes and pads
At the factory, a water retaining ring
(Fig. 4/1) is fitted to the brushes which
reduces water consumption consider-
ably during scrubbing.
Fig. 4
Refer to Section 4 for the brushes avail-
able.
Switch off the scrubbing unit,
set the key switch to position 0
and remove the key.
Installing the brushes
The brush locks, supplied loose in the
vehicle's accessories kit, must be as-
sembled on the brushes in accordance
with Figure 5/1:
Fig. 5
1. Pivot up the side panels at the bot-
tom left and bottom right.
2. Slide the brush under the brush head
in accordance with Figure 5.
3. Raise the brush and turn slightly until
the toothing meshes.
4. Then pull the brush up until all six
hooks engage in the catches.
5. Rotate the brush once to check that
all the hooks are engaged.
6. Close the lock on the brush,
see Figure 6.
Lock closed
Lock open
Fig. 6
Installing the drive plates with pad
1. Turn the drive plate over and place
the pad on the contact surface, press
on and fix in place with the center-
lock.
2. Lock the drive plate with the pad in
the catches as described in para-
graph ”Installing the brushes”.
Brush selection
The Hakomatic B1050 must be
equipped with the brushes and pads
from the accessories program accord-
ing to the accumulation of dirt and char-
acteristics of the floor; also refer to
Section 4.
1
1