9
Safety Information
hood is closed and locked and the
lever of the shaking device has been
pushed in.
• Before starting work, the operator
must be fully familiar with all
adjustment, operating and control
elements as well as their respective
function! It is too late to do this when
the machine is actually in operation!
• Always wear heavy duty, non-slip
footwear when working with the
machine.
• The machine may only be used on
those surfaces which have been
approved by the contractor or person
appointed by him.
• The manner of driving must be
adapted to the local conditions.
• It is forbidden to use the machine in
potentially explosive atmospheres.
• Do not let the engine run indoors!
Risk of poisoning (only Hako
Hamster 800 V)! Ensure sufficient
ventilation when working indoors.
• When using the machine, it is
essential to pay attention to third
parties, especially children.
• Pay attention to hot parts of the
engine, risk of burns.
• It is prohibited to transport
passengers.
• Accelerate the machine immediately
after switching on the rotary brush,
otherwise imprints of the brush could
be produced on the floor.
• Never leave the machine unattended
as long as the engine is running.
• Remove the ignition key to prevent
unauthorized use of the machine.
• Never leave batteries in a
discharged state but recharge them
as soon as possible (only Hako
Hamster 800 E).
• When transporting the machine,
switch the engine off and raise the
side brush.
• The Hako Hamster 800 V can be
used on surfaces with a maximum
gradient of 15%.
• The Hako Hamster 800 E can be
used on surfaces with a maximum
gradient of 10% (for maximally 3
minutes).
• Steps or curbs up to a maximum of
4 cm can be driven over.
• It is forbidden to manipulate switches
and safety equipment.
