25
Starting Up
Adjusting the squeegee
The squeegee must be set up on a level
floor according to the conditions in
which it is to be used. The squeegee
must stand vertically on the floor (ad-
justed at the factory). The sealing strip
(Fig. 10/3) should bend slightly to the
rear when the vehicle is in operation.
Supporting rollers (Fig. 10/5) limit its
movement toward the floor. These sup-
port rollers must be adjusted in order to
raise the contact surface of the squee-
gee:
• Loosen the counternuts (Fig. 10/4)
and raise the supporting rollers on
the left and right evenly (turn screw
counterclockwise and lock again).
The sealing strip now bends a little
more towards the rear. An
adjustment of the supporting rollers is
also necessary when the edge of the
sealing strip is worn.
2.3.3 Adjusting the driver's seat
The driver's seat (Fig. 11) must be ad-
justed so that the driver is seated com-
fortably and can reach all the operating
elements with ease.
The vehicle is equipped with a
seat contact switch. The
vehicle can only be operated
when the operating person is
seated on the seat.
The scrubber drier is equipped with a
driver's seat which can be adjusted in a
longitudinal direction (forward and
back):
1. Press the lever on the right of the
seat outwards slightly.
2. Slide the seat forward or back in
steps of 15 mm.
Fig. 11
