56
Operation
Wet scrubbing and vacuuming dry
This program is the standard cleaning
program for this vehicle.
• Press the green Hako
button (Fig. 19/15) on the
left-hand operating panel.
Various functions can be switched on or
off with the following buttons according
to the conditions at the location of use:
Fig. 24
• Increase brush pressure (Fig. 24/1)
• Reduce solution quantity (Fig. 24/2)
• Increase solution quantity (Fig. 24/4)
• Solution feed on/off (Fig. 24/3)
Check whether the floor is
sufficiently dry at regular
intervals, otherwise people
could slip. If the floor is
excessively wet, check the
vehicle for leaks and that the
sealing strips are in a good
condition. If the sealing strips
are damaged, change them;
refer to Section 5.8.4.
Wet scrubbing (basic cleaning)
If you do not want to vacuum the floor
dry in the same working procedure be-
cause you want the solution to soak into
the dirt, for example, activate this pro-
gram.
Wet floors are a potential risk
for slipping! Ensure to provide
the corresponding information
and warning signs.
brush drive” button (Fig.
19/9) on the left-hand
operating panel.
Various functions can be switched on or
off with the following buttons according
to the conditions at the location of use:
• Increase brush pressure (Fig. 24/1)
• Reduce fresh water quantity
• Increase fresh water quantity
• Solution feed on/off (Fig. 24/3)
2
3
4
1
