38
Operation
,QGLFDWRUILHOG
)LJ
The indicator field enables the scrubber
drier to provide feedback on the operat-
ing status of the vehicle. This only re-
lates to operating states which cannot
be switched on and off via the operating
panel: recovery tank full, parking brake
applied and error message.
The individual buttons and functions are
described in detail below:
,QGLFDWRUIRUUHFRYHU\WDQN
PD[LPXPILOOOHYHO
)LJ
The yellow control lamp lights
up when the recovery tank has
reached its maximum fill level. Also, a
"beep" signal is issued every 15 sec-
onds. In this case, a float switch switch-
es the suction turbine off and the
squeegee is raised.
,QGLFDWRUIRUSDUNLQJEUDNH
DSSOLHG)LJ
The control lamp lights up red
when the parking brake has
been actuated via the pedal to
the left of the steering column. If the
traction drive is switched on, an acous-
tic signal is also issued.
,QGLFDWRUIRUIXQFWLRQIDXOWV
)LJ
The control lamp lights up red
when one of the following
faults occurs:
• The thermostatic switch disconnects
from the brush or hydraulic motor.
• One of the safety fuses is defective
or an electronic fuse has been
tripped.
• Another fault has occurred.
At the same time, a four-digit code ap-
pears in the display of the service indi-
cator (Fig. 17/5). This error code infers
which fault has occurred (refer to Sec-
tion 3.5.1). At the same time, the control
lamps flash and an acoustic, pulsating
signal is issued.
Summary of Contents for Scrubmaster B310 R/TB 1020
Page 1: ...QVWUXFWLRQ 0DQXDO 6FUXEPDVWHU 5 7...
Page 98: ...98 Maintenance and Service...