54
Operation
8VHIXOWLSVIRUFOHDQLQJ
• Sweep the floor before starting wet
cleaning. This not only improves the
cleaning effect but also reduces the
vehicle's liability to wear.
• The floor should be treated twice in
the case of particularly dirty floors or
to remove wax (basic cleaning).
- During the first cleaning process,
the floor is scrubbed with a clean-
ing agent dosage appropriate to the
degree of soiling, whereby the
squeegee is raised.
- Let the cleaning solution work into
the floor for 5 to 10 minutes accord-
ing to the manufacturer's informa-
tion.
- Then scrub the floor again with the
squeegee lowered.
• Observe the correct dosage of the
cleaning agent. Information on dos-
age is provided on the cleaning
agent container.
• Use the manufacturer's information
as an initial basis. Practical experi-
ence will ensure that you quickly find
out which is the right Hako cleaning
agent and the optimum dosage to
suit your needs.
The correct dosage helps to re-
duce costs and protect the en-
vironment.
The development of excessive
foam impairs the vehicle's
function.
• Cause: Too much cleaning agent
leads to certain component parts of it
getting into the waste water resulting
in the development of foam. This in-
dicates that the amount and mixture
of solution do not match the level of
dirt.
6ZLWFKLQJWKHYHKLFOHRII
• Turn the key from position 1 to lock
position 0. The vehicle is no longer
ready to operate.
• Remove the key from the key switch.
Apply the parking brake!
/RDGLQJDQGWUDQVSRUWLQJWKH
YHKLFOH
Refer to Section 5.12.
Summary of Contents for Scrubmaster B310 R/TB 1020
Page 1: ...QVWUXFWLRQ 0DQXDO 6FUXEPDVWHU 5 7...
Page 98: ...98 Maintenance and Service...
