86
Maintenance and Service
(PSW\LQJWKHUHFRYHU\WDQN
The recovery tank
(Fig. 26/3) must be emptied
and flushed clean after finish-
ing work.
Observe the applicable laws
and local regulations when dis-
posing of waste water contain-
ing cleaning agents!
1. Park the vehicle so that the waste
water draining hose (Fig. 26/6) can
be positioned over a drain in the
floor.
2. Open the left and right rear doors.
3. Detach the waste water draining
hose (Fig. 26/6) and lower it slowly.
4. Unscrew the screw cap (Fig. 26/5).
The quantity drained can be regulat-
ed by turning the cap and pivoting
the cap open fully, if necessary.
5. When the recovery tank has been
completely emptied, screw the cap
shut again and attach the draining
hose again.
If the recovery tank is extreme-
ly dirty, begin cleaning the tank
straight away.
6. Close the left and right rear doors.
&OHDQLQJWKHUHFRYHU\WDQN
Clean the recovery tank (Fig. 26/3) ev-
ery day or as necessary. The cleaning
flap (Fig. 26/7) is available for this.
The cleaning flap must not be
used to drain off waste water.
1. Open the left and right rear doors.
2. Empty the recovery tank, refer to
Section 5.6.1.
)LJ
3. Pull out the run-off plate (Fig. 27/3).
4. Release the flap lock: turn the wing
nuts (Fig. 27/1) counterclockwise.
2
3
1
Summary of Contents for Scrubmaster B310 R/TB 1020
Page 1: ...QVWUXFWLRQ 0DQXDO 6FUXEPDVWHU 5 7...
Page 98: ...98 Maintenance and Service...
