34
03-7175-00-00.fm
Putting into service
3.3.1
Installing the mains cable
1. Remove the cover
Fig. 11-A.
2. Route the cable of the mains plug
Fig. 11-B
through the opening in the
bracket
Fig. 11-C.
Ensure that the side of the strain relief without a latch
faces the front towards the opening.
3. Press the strain relief into the bracket until all latches have engaged.
4. Plug the mains plug
Fig. 11-D
straight and firmly into the holder.
5. Reinstall the cover using the available screws.
3.3.2
Adjusting the driver's seat
The driver's seat can be adjusted to three positions.
1. Open the seat console.
2. Loosen the screws and remove the washers. Hold the seat while doing this.
3. Set the seat to the desired position.
4. Tighten the screws and washers at the respective position.
Attention
For reasons of safety, the driver's seat is equipped with a seat
contact switch. The function of the seat contact switch must not be
bypassed.
Fig. 11:
A
C
B
D
Fig. 12: