1
0
Replacement of main
broom
The broom roller bears 10 ea. rows of
alterned soft and hard bristles and
consists of two broom halves.
Width:
480 mm (18.9")
Dia.:
250 mm (9.8")
Dia, wear limit: approx. 180 mm (7.1")
The broom roller is replaced as
follows:
Slue side broom up
Tilt machine back to rest on the
handlebar
Remove three ea. Phillips screws,
turn broom roller 180°, remove
Phillips screws from second half. Pull
the drive pin out of the broom shaft.
To install, reverse above procedure.
10
Replacement of main
broom
The broom roller bears 10 ea. rows of
alterned soft and hard bristles and
consists of two broom halves.
Width:
480 mm (18.9")
Dia.:
250 mm (9.8")
Dia, wear limit: approx. 180 mm (7.1")
The broom roller is replaced as
follows:
Slue side broom up
Tilt machine back to rest on the
handlebar
Remove three ea. Phillips screws,
turn broom roller 180°, remove
Phillips screws from second half. Pull
the drive pin out of the broom shaft.
To install, reverse above procedure.
Summary of Contents for Sweepmaster M600
Page 1: ...OTUSVDUJPO BOVBM Instruction Manual Sweepmaster M600...
Page 2: ......