6-28
HAKUBA 26PPM Laser Printer - Base Engine Technical Manual
Version 1.0
Secondary FIPs
6.20 Electrical Noise
Step
Actions and Questions
Yes
No
1
INITIAL ANALYSIS
Inspect the following components.
•
PWBA HKB26 MCU
(PL10.1.13)
•
PWBA HVPS
(PL10.1.20)
•
Fuser Assy
(PL6.1.7)
• Heat Rod
•
Harness Assy Fuser -M (J271,J11, J27, J262)
(PL6.1.12)
•
PWBA HKB PS
(PL10.1.17)
•
CRU
•
P/H Assy
(PL5.1.4)
•
Resist Buffle
(PL5.1.25)
•
BTR Chute Assy
(PL6.1.1)
•
Spring Earth Exit
(PL7.1.24)
•
Chute Assy MBF
(PL4.1.1)
•
Cover Assy Front
(PL1.1.9)
Are they compatible with your printer version, correctly
installed, not damaged, deformed, or contaminated?
Go to step 2
Replace the
problem com-
ponents
2
Check the AC power cord and the AC wall outlet.
Is the printer properly grounded?
Go to step 3
Ground the
printer
3
Check the area around the printer.
Is there an electrical device, such as a generator or an
appliance, near the printer.
Move the
device, or
relocated the
printer.
Go to step 4
4
P/H ASSY
(PL5.1.4) ANALYSIS
Check to make sure the
Springs Earth
are firmly attached to
the
P/H Assy
.
Are the
Springs Earth
firmly attached to the
P/H Assy
?
Go to step 5
Re-secure the
Spring Earth
Summary of Contents for b 6100
