3-4
HAKUBA 26PPM Laser Printer - Base Engine Technical Manual
Version 1.0
Primary FIPs:Error Codes
HAKUBA Error Codes continued
Code
--
Message
Cause
Results
-------------
How to Clear the Code
(If you cannot clear the code, go to the
appropriate error code FIP, or to the
option service manual)
E5
--
CLOSE TOP /
REAR
COVER
The Cover Assy Front and/or the Cover Rear are/
is open.
Motor Assy Main, Laser Scanner, and
Fuser Assy controls stop immediately.
-------------
Close the open cover.
E5
--
FACE UP TRY
OPEN
The Cover Assy Rear Face Up is open.
Motor Assy Main, Laser Scanner, and
Fuser Assy controls stop immediately.
-------------
Close the open cover.
E4
--
E4-2:EXIT
JAM
There is a paper jam for the standard cut paper at
the Sensor Exit.
1. The Sensor Photo:Exit does not turn OFF
within the specified time after the Sensor Photo:
Exit turning ON.
2. The Sensor Photo:Exit turns ON immediately
after the power is turned on or when the Cover
Assy Front is close.
Motor Assy Main, Laser Scanner, and
Fuser Assy controls stop immediately.
-------------
Open the Cover Assy Front or Rear.
Remove the jammed paper.
Close the Cover Assy Front or Rear.
E4
--
E4-3:EXIT
JAM
There is a paper jam at the Sensor Exit.
The paper of Universal or Custom does not actu-
ate the Sensor Photo:Exit within the specified time
from the Sensor Photo Regi OFF timing.
Motor Assy Main, Laser Scanner, and
Fuser Assy controls stop immediately.
-------------
Open the Cover Assy Front or Rear.
Remove the jammed paper.
Close the Cover Assy Front or Rear.
E3
--
E3-1:REG
JAM
There is a paper jam between the Sensor
Photo:Regi and the Sensor Exit in the Fuser Assy.
The paper does not actuate the Sensor Exit of the
Fuser Assy within the specified time after the Sen-
sor Photo:Regi activated.
Motor Assy Main, Laser Scanner, and
Fuser Assy controls stop immediately.
-------------
Open the Cover Assy Front.
Remove the jammed paper.
Close the Cover Assy Front.
E3
--
E3-2:REG
JAM
There is a paper jam at the Regi position.
The Sensor Photo:Regi turns ON immediately
after the power is turned ON or when the Cover
Assy Front is close.
Motor Assy Main, Laser Scanner, and
Fuser Assy controls stop immediately.
-------------
Open the Cover Assy Front.
Remove the jammed paper.
Close the Cover Assy Front.
Summary of Contents for b 6100
