7
8
The
Halco ProLED
®
Nicheless LED Lights
are low voltage light fixtures. Improper
wire gauge and/or wire length can affect the performance of these lights. Follow the
guidelines below to determine the proper operation and optimum performance of
the lights.
Voltages are determined by the measured voltage level at the bus bar where the
transformer and cords are connected.
NOTE:
Each color mode has a slightly different power draw.
Cord Length
Min Voltage
Max Voltage
50 feet
9.4VAC
12.4VAC
100 feet
10.7VAC
13.2VAC
150 feet
11.82VAC
13.8VAC
WIRE GAUGE AND LENGTH
WARNING
Which could result in serious injury or death. A Ground Fault Circuit Interrupter (GFCI)
for 120 Volt transformers should be used if required by the transformer manufacturer
or if required by the local state or city code. When a GFCI is used, the conductors
on the load side of the GFCI circuit shall not occupy conduit, boxes, or enclosures
containing other conductors unless the additional conductors are also protected by a
GFCI. Refer to local state and city codes for complete details.
RISK OF ELECTRIC SHOCK OR ELECTROCUTION.
WARNING
Which could result in serious injury or death. The
Halco ProLED® Nicheless LED Lights
are only
available for 12VAC power. For supply connection, use only an isolating low voltage power supply with
ungrounded output, evaluated and listed by a Nationally Recognized Testing Laboratory (NRTL) for
swimming pool use.
RISK OF ELECTRIC SHOCK OR ELECTROCUTION.
WARNING
WIRING TO A SWITCH
*If required by transformer manufacturer's instructions or by local state/city code requirements.
Figure 5:
Wiring
Halco ProLED
®
Nicheless LED Underwater Lights
.
Aqualink
®
Aux Relay or Switch.
Black
Line
GFCI*
Black
White
White
Green
White
Neutral
Ground
Ground
Black
120 volts to 12VAC
transformer.
Halco ProLED
®
Color-Changing Light
and
Halco ProLED
®
White Lights
Nicheless LED
light
F
ixtures
are operated through the light’s switch. No special
controller or interface is required, Use a junction box to connect and operate
multiple lights with a single switch.
OPERATING THE HALCO PROLED
®
COLOR CHANGING
& HALCO PROLED
®
WHITE NICHELESS LED LIGHTS
A 12-14 VAC Transformer must be used to power all 12VAC
Halco ProLED
®
Nicheless LED Lights.
NOTE:
For optimum performance Halco recommends not exceeding the load factor
specified by the instructions included with the transformer.
To ensure maximum safety, only use a transformer that can supply 12VAC and is listed
or certified by a Nationally Recognized Testing Laboratory (NRTL) as compliant with
UL 379, Standard for Power Units for Fountain Luminaires, Swimming Pools and Spas.
12VAC INSTALLATION
To prevent the risk of fire which could result in property damage, void the warranty, as well
as to ensure optimum performance from your
Halco ProLED
®
Nicheless LED Lights,
do
not exceed the load factor specified in the instructions provided by the manufacturer of
the transformer.
WARNING
