THIS WAY UP
THIS WAY UP
Installation of the Stability Module (cont’d)
Position of ITCM Stability Module Assembly
If the Stability Module is to be frame mounted follow these guidelines:
The ITCM Stability Module Assembly must be
mounted vertically.
Position the Assembly as high as possible in the chassis
to provide protection from direct spray and other road
debris. This will also protect the Assembly against high
pressure cleaning and allow acceptable hose routing.
The hose connection between the reservoir and the Stability
Module Port 2-1 should be as short as possible. Use nylon
tubing no smaller than 1/2” in diameter and no longer than
13 feet (4 m) in length.
Torque the Port 2-1 fittings to a value of 55-70 ft.-lbs. DO NOT
use teflon tape.
If the Stability Module is to be mounted to a bracket, follow
these guidelines:
Additional bracket design should be as rigid as possible.
The mounting must provide an electrical connection between
the ITCM Stability Module ECU and the vehicle chassis.
The mounting bracket flatness must not deviate more than
.020 in (0.5 mm) from its true plane. The surface must lie
between two parallel planes .020 in (0.5 mm) apart.
Secure the ITCM Stability Module using bolts, flat
washers and non-corrosive self-locking nuts.
The recommended fixing screw bolt size is
5/16-18 in (M8 x 1.25) with a 13/16 in (20.5 mm)
washer. Fixed with a minimum torque of
25 --- 24 ft-lb (35 --- 32 nm).
The ITCM Stability Module mounting bolts, washers,
locking nuts, etc. must be protected from corrosion to
give 200 hours salt spray resistance.
Check continuity between ITCM Stability Module
mounting and the vehicle frame. Resistance (R) should
be less than 5 ohms (0 < R < 5 ohms).
STABILITY MODULE
INSTALLATION/SERVICE
GUIDE (L31288W)
TM
.02” (.5 mm)
.16” (4 mm)
minimum
Mounting
Bracket
Fixing
hole
Fixing
Screw
0
5Ω
Page 9
Contact
Required
