HALE MiniCAFS 2.1A Description, Installation And Operation Manual Download

Page: 7 / 102

Page

SmartFOAM

SAFETY

IMPORTANT!

ALL HALE SMARTFOAM MODELS ELECTRONIC

FOAM PROPORTIONING SYSTEMS ARE DE-

SIGNED FOR OPTIMUM SAFETY OF ITS OPERA-

TORS AND TO PROVIDE RELIABLE AND SAFE

FOAM CONCENTRATE INJECTION. FOR ADDED

PROTECTION AND BEFORE ATTEMPTING INSTAL-

LATION OR OPERATION PLEASE FOLLOW THE

SAFETY GUIDELINES LISTED IN THIS SECTION

AND ADHERE TO ALL WARNING, DANGER, CAU-

TION AND IMPORTANT NOTES FOUND WITHIN

THIS GUIDE.

THIS SECTION ON SAFETY MUST BE CAREFULLY

READ, UNDERSTOOD AND ADHERED TO

STRICTLY BY ALL INSTALLERS AND OPERATORS

BEFORE ATTEMPTING TO INSTALL OR OPERATE

THE SMARTFOAM PROPORTIONING SYSTEM.

INCORPORATE THE WARNINGS AND CAUTIONS

AS WRITTEN WHEN DEVELOPING DEPART-

MENTAL APPARATUS OPERATING PROCEDURES.

SmartFOAM is a trademark of Hale Products, In-
corporated. All other brand and product names are
the trademarks of their respective

holders.

GUIDELINES

READ ALL INSTRUCTIONS THOROUGHLY BEFORE
BEGINNING ANY INSTALLATION OR OPERATION
PROCESS.

❑

Installation should be performed by a trained and
qualified installer, or your authorized Hale Prod-
ucts service representative.

❑

Be sure the installer has sufficient knowledge, ex-
perience and the proper tools before attempting
any installation.

❑

Make sure proper personal protective equipment is
used when operating or servicing apparatus.

❑

A foam tank low level sensor must be utilized to
protect the Hale Foam proportioner from dry run-
ning.

Failure to use a low level sensor with the

Hale Foam system voids warranty.

❑

DO NOT permanently remove or alter any
guard or insulating devices, or attempt to op-
erate the system when these guards are re-
moved.

❑

Make sure all access/service panels and covers
are installed, closed and latched tight, where ap-
plicable.

❑

DO NOT remove or alter any hydraulic or  pneu-
matic connections, electrical devices,  etc. DO
NOT tamper with or disconnect safety  features or
modify protective guards (such as covers or
doors). DO NOT add or remove  structural parts.

Doing so voids the warranty.

Any of the above could affect system capacity  and/or
safe operation of the system and is a serious safety
violation which could cause  personal injury, could
weaken the construction  of the system or could affect
safe operation of  the SmartFOAM Proportioning Sys-
tem.

WARNING!

NO MODIFICATIONS OR ADDITIONS MAY BE
MADE TO THE SMARTFOAM PORPORTIONING
SYSTEM WITHOUT PRIOR WRITTEN PERMISSION
FROM:

HALE PRODUCTS, INC

607 NW 27

Avenue

Ocala, Florida 34475 USA

Telephone: 352-629-5020

FAX: 800-533-3569

❑

All electrical systems have the potential to
cause sparks during service. Take care to elimi-
nate explosive or hazardous environments dur-
ing service and/or repair.

❑

To prevent electrical shock always  disconnect the
primary power source  before attempting to service
any part of the  Hale Foam system.

❑

To prevent system damage or electrical shock
the main power supply wire is the last connec-
tion made to the Hale Foam motor controller.

❑

Release all pressure then drain all concentrate and
water from the system before servicing any of its
component parts.