Features
Turn the Unit ON/OFF
Headset On
1. Pressing down the
MFB
for 3 seconds. The BTD-6 headset will turn ON. When it is ON, a
low-high tone is heard and the Indicator A (blue LED) will flash 5 times and then go on. After
releasing the
MFB
, the light will blink that Indicates the unit is waiting for a call
（
standby
mode
）
.
2. If the Indicator A turns red, it means that the battery on the headset is low. Re-charge the
headset immediately.
Headset Off
Press the
MFB
for about 3 seconds and it will be turned OFF. A high-low tone will be heard and
the Indicator A will flash red light 5 times and then go out. Turn off the headset is necessary to
conserve battery life if the headset will not be used for a long time.
Pairing to the Phone
Before use, the headset must be paired with the phone. Pairing needs to be done only once.
When the phone and the unit have been paired, connecting to the phone will be used by pressing
the
MFB
of the headset once every time the phone is turned on for use.
Enter into Pairing Mode
（
a
）
First, this unit must be preset under standby mode – Indicator A
(blue LED) blinks every 3
seconds.
（
b
）
To enter into pairing mode,
(1) First, set this unit under OFF mode.
（
To enter into OFF mode, please press the
MFB
for
3 seconds until Indicator A (red LED) flashes 3 times and then goes off. A high-low tone
will sound when the phone is turning off.
）
(2) Press
MFB
for 5 seconds
（
approx.
）
until Indicator A (blue LED) blinks 10 times and then
goes into blue and red flash interchanged. Meanwhile, two beeps come and the Headset
will be in “pairing mode”.
(3) Key in the PIN Code “1234”.
（
This can be customized upon customer’s request.
）
Press
“ OK’ to complete Pairing.
（
Pairing procedure might be varied because of different
phones. Therefore, users are recommended to refer to their individual Phone type User’s
Manual.
）
Meanwhile, this unit is under standby mode-Indicator A (blue LED) blinks
every 3 seconds, or in connection status - Indicator A (blue LED) blinks 3 times in every 3
seconds (Headset in standby mode or in connection status depends on the cellular
phone) on your Bluetooth enabled cellular phone after you have preset to pairing mode
with headset.
Answering/Receiving a call
2
When phone is receiving a call, the phone ring tone will be heard on the headset, pressing the
