HDMI + USB + LAN Sender and Receiver
6
DC 48V POWER
Plug the 48V DC power supply into the unit and connect the adaptor to an AC outlet
and the LED will illuminate.
4.2 Transmitter’s Rear Panel
HDMI IN
Connect this port to the HDMI source equipment such as a DVD or Blu-ray player.
USB
Connect this port to a USB Host system such as a PC.
SPDIF OUT
Connect to an audio system with digital input. The audio source is either the SPDIF
connector on the receiver or the ARC pin of the HDMI Output (user selectable). This
signal can be 2-channel PCM, or multi-channel (Dolby or DTS). The UH2X passes
this signal from the Receiver to the Sender just as is without any modification. If you
need convert it to analog, use Hall Research's4.3 Receiver’s Front Panel
RS-232
Connect to the device that has to be controlled. Pin 2=RX, Pin 3=TX, Pin 5=GND.
IR IN
Connect the supplied IR Detector cable for IR signal reception.
IR OUT
Connect the supplied IR Emitter cable for IR signal transmission
LAN
Connect to Ethernet port of any network enabled device
