UHBX-3S / -6S
4
© Copyright 2019 Hall Research, Inc.
Features
•
Splits HDMI for up to 3 or 6 remote displays via HDBaseT
•
HDMI output for connection to a local display or daisy-chaining
•
Extends HDMI, Power (PoH), and RS-232 on Cat 6 to 500 ft (150 m)
•
Supports most HDMI and DVI resolutions
•
Advanced EDID management with USB port for EDID manipulation using
a PC
•
Can address and send independent RS-232 commands to each HDBaseT
output.
•
RS-232 commands can be sent at any baud rate up to 115200
•
Complies fully with HDBaseT standard
•
Power-over-HDBaseT(PoH) meets IEEE802.3af standard
•
RS-232 expansion port for daisy-chaining multiple UHBX-3S/6S units
•
Fully isolates ground between TX and RX sides
•
Sturdy metal enclosures with mounting provisions
2.0 Package Contents
(x1) The Splitter unit
(x1) 48v, 1.5A universal power supply (part number
511-PS4815
)
(x1) 1m HDMI Cable
(x1) 2m DB9 (RS-232) M/F cable
(x1) 1m USB /A to Mini USB /B cable
(x1) User’s Manual
3.0 Setup
Installation
As shown in the diagram below, the UHBX-3S/6S can extend a single video
source to multiple remote displays. There is also an additional HDMI output
for connection to a local display or for daisy chaining to another Splitter. A
maximum of (7) Splitters can be daisy-chained together.
RS-232 and Power (PoH) signals are also extended on the same Cat 6 cable to
compatible Receivers. The RS-232 IN port is used to send/receive commands
or data to/from remote displays connected at the output. Special RS-232
commands must be used to communicate with any individual output (Refer to
Section 5 for more details).
Summary of Contents for UHBX-3S
Page 11: ......
