UI-IP8-DP
6
© Copyright 2018 Hall Research, Inc.
Rear Panel Connections
DC 5V: Connect to the supplied 5V DC power supply if no PoE power is available from the
network switch / router.
Control: Connect to a compatible LAN network switch or router using a CAT5e/6 cable.
Power over Ethernet (PoE) is supported; this enables the unit to be powered directly from the
48V network switch / router without the need for the 5V DC power supply to be connected.
Relay Out: Connect to a device that supports DC 0~30V/5A relay trigger.
4.0 Configuration and Control via Web GUI
4.1 Install the Hall Research Device Finder (HRDF) Software Tool
The default STATIC IP address as shipped from the factory (or after factory default reset) is
192.168.1.50.
If multiple keypads connected to your network, or you are unsure of the IP addresses
assigned to each keypad; free HRDF Windows® software is available for download on the
product webpage. The user can scan the compatible network and find all the attached UI-IP8-
DP keypads. Note that HRDF software may discover other Hall Research devices on the
network if present.
NOTE
There is a mini-USB connector accessed from the front by removing the
Decora cover. This port is only for updating the firmware.
