Model
Subject to technical changes
Installation TopFix / RecessFix [R1]
Do not damage the product when using a sharp
knife to open the packaging!Fitting screws: Use a
size-2 screwdriver (PO ZIDRIVE) or use an electric
screwdriver at it’s lowest torque. Rail removal: Use a
use the original screws enclosed, to prevent
malfunctioning from using too thick screw heads!
A
B
C
Removal
X=5 cm
x x
max. 70 cm
Rail installation sequence on Clips
3-A1
3-A2
4
Connection
2
1
Cover installation
A
3
Installation
Clip installation
The built-in motor (24 V DC) with automatic end position adjustment
may only be connected to the 230V mains using a stabilized 24 Volt DC
Power Supply.
Only use Power Supplies and controls recommended
by the manufacturer of the Pleated Blind, to prevent damage or
malfunctioning caused by non-compatible electric components!
When connecting electric components, the wiring diagram provided by
the manufacturer of the Power Supply must be observed.
[R1]
18-04-2014
AE10
Hallis Hudson, Unit C34, Red Scar Business Park, Longridge Road, Preston, Lancashire, PR2 5NN
Sales Tel: 01772 202 202 | Sales Fax: 01772 515 515 | Email: sales@hallishudson.com | www.halliswebshop.com
www.hallishudson.com
