If necessary, adjust the position of the cord
pulls by removing the cord connector and
cutting off more chain so they sit in your chosen position.
Using a T10 torx key tighten up both screws
on the top side of the headrail as well as the
Cut two chains to the desired length, we
recommend the front chain is 4cm shorter than
the back to help differentiate between the two.
Take a small pick tool and pull the clear ball
chain connector from the inside of the white
Take your chosen cord pull and pass your
chain through the small opening in the end.
chain connector to the bottom of the
chain, Repeat the process for the second chain.
Position the spools where required and attach
the cord to each spool ensuring that you fully
press down on the grey button.
Pass the cord through the cord guide.
You can now attach your blind to the headrail and
continue to cord up the blind in your usual way.
