USA-CAN - 25
NOTE:
The program duration may change according to the amount of dishes, the water
temperature, the ambient temperature in the room, and any selected additional functions.
NOTE:
The energy-usage label is based on the “Regular” cycle. This cycle is the most ef
-
ficient in terms of its combined energy and water consumption at cleaning normally soiled
dishes. The Energy Guide Label is based on the normal soil detection cycle. In this cycle,
the dishwasher was tested without any rinse aid in the rinse aid dispenser, with a single
dose of detergent in the detergent dispenser and detergent used for the prewash step. For
cycles with prewash, a dose of detergent can be added on the inside of the cabinet door.
We recommend that the rack position for crockery loads be set to the highest position as in
the energy certificate test.
• Only use powder detergent for short programs.
• Short programs do not include drying.
• To assist drying, we recommend slightly opening the door after a cycle is complete.
Water Temperature
Hot water is needed for best dishwashing and drying results. Water entering dishwasher
should be at least 120°F (49°C) to give satisfactory results.
To check water temperature entering dishwasher:
• Turn on hot water faucet nearest dishwasher for several minutes to clear cool water from
pipes.
• Hold a candy or meat thermometer in stream of water to check the temperature.
• If temperature is below 120°F (49°C), have a qualified person raise the hot water heater
thermostat setting.
Salt Indicator (Model Depending)
Please check the salt indicator on the control panel to see whether there is adequate
amount of softening salt in the dishwasher or not. You need to refill the salt reservoir with
salt whenever salt warning indicator appears on the control panel of your machine. In order
to add salt to the machine,
1. Open the door of the machine,
2. Press and hold “Start/Pause + On/Off” key for 3 seconds,
3. Immediately after the machine gives an audible warning, release “Start/Pause + On/
Off” key, press and hold “Program Sel Cancel” key until “SL” is represented on the
display. The machine will display the last setting,
4. The amount of Salt is adjusted by pressing “Program Sel Cancel” key,
5. After the adjustment, turn off (by pressing Start/Pause + On/Off key) the machine to save
the selected salt amount.
