ELECTRIC BICYCLE METER — LCD3 Product User Manual
- 20 -
P1 parameter setting interface
Under P1 parameter setting interface, if there’s no button operation on the
meter for more than 1 minute, and then the meter will automatically return to display
1, and the original set parameter will be saved.
After finishing P1 parameter setting, hold
button shortly to save the current set
values and enter P2 parameter setting interface.
○
P2 Wheel Speed Pulse Signal Setting Mode
Enter P2 parameter setting interface after P1 parameter setting is finished, and P2
parameter column flashes.
P2 parameter setting interface
P2 is wheel speed pulse signal setting mode. If wheel generated 1 pulse signal by a
revolution, P2 should be set as1. If wheel generated 6 pulse signals by a revolution, P2
should be set as 6. If users didn’t configure the pulse signal system, and then P2 parameter
setting can be 0. The setting range of P2 should be between 0-6, hold
button (
UP
)
shortly or
button
(DOWN)
for selection.
Under P2 parameter setting interface, if there’s no button operation on the meter
for more than 1 minute, and then the meter will automatically return to display 1,
and the original set parameter will be saved.
www.HalloMotor.com
