ELECTRIC BICYCLE METER — LCD3 Product User Manual
- 22 -
P4 parameter setting interface
P4 is handlebar startup mode. When P4 setting is 1, indicating the handlebar is under
"
non-zero startup
" mode, namely, the handlebar can be effective only after startup the
foot power assist. When P4 setting is 0, indicating the handlebar is under "
zero startup
"
mode, the motor can be startup by the handlebar directly. P4 setting range is 0 or 1, hold
button (
UP
) or
button
(DOWN)
shortly for selection. P4 parameter setting
method is the same to that of P2.
○
P5 Power Monitoring Mode
Enter P5 parameter setting interface after P4 parameter setting is finished, P5
parameter column flashes.
P5 parameter setting interface
P5 is power monitoring mode, when P5 setting is 0, the power monitoring is the
"
real-time voltage
" mode. Namely, it is the method to determine the battery capacity
based on real-time battery voltage. When P5 equals to a specified parameter, the power
monitoring is the "
smart power
" mode (this parameter is determined by the battery
characteristics, ordinary 24V lithium is generally is 4-11, 36V lithium is between 5_15). P5
setting ranges from 0-40, hold
button (
UP
) or
button
(DOWN)
shortly for
selection. P 5 parameter setting method is the same to that of P2.
After finishing P5 parameter setting, hold
button (
SW
) shortly to save current
set the values, and then P5 parameter column stops flashing. Hold
button (
SW
)
shortly again, the meter re-enter P1 parameter setting interface. Or hold
button (
SW
)
long for about 2 seconds to exit P parameter setting environment and return to the display
www.HalloMotor.com
