ELECTRIC BICYCLE METER — LCD3 Product User Manual
- 24 -
02
Lowest
07
Lowest
Forward 8 Signal
00
Higher
Reverse 10 Signal
05
Higher
01
Standard
06
Standard
02
Lower
07
Lower
Forward 10 Signal
00
Highest
Reverse 12 Signal
05
Highest
01
Higher
06
Higher
02
Standard
07
Standard
After finishing C1 parameter setting, hold
button (
SW
) shortly to save the
current set values and enter C2 parameter setting interface.
○
C2
Motor Phase Classification Coding Mode
Enter C2 parameter setting interface after C1 parameter setting is finished, C2
parameter column flashes.
C2 parameter setting interface
C2 is motor phase classification coding mode. It is served as identification parameter
of different phases of the motor when using sine wave drive and the default value is 0.
When C2 setting is 0, indicating that the used Quantum motor phase is an ordinary one.
When the setting is a certain value, indicating a particular motor phase is used. C2 setting
range is 0-7, hold
button
(UP)
or
button (
DOWN
) for selection.
After finishing C2 parameter setting, hold
button (
SW
) shortly to save the
current set values and enter C3 parameter setting interface.
www.HalloMotor.com
