ELECTRIC BICYCLE METER — LCD3 Product User Manual
- 32 -
When the meter is needed to restore default setting, C10 selects y, hold
button
long for about 2 seconds, all parameters restore default settings and exit setting
environment, and then return to the display1.
C10 selects n, hold
button
(SW)
shortly to save the current set values and enter
C11 parameter setting interface.
○
C11 Attribute Selection Mode
Enter C11 parameter setting interface after C10 parameter setting is finished, C11
parameter column flashes.
C11 parameter setting interface
C11 is meter attribute selection mode. The setting range is 0-2, hold
button
(UP)
or
button
(DOWN)
shortly for selection.
C11 parameter definition table
：
C11
value
Meter Attribute
0
Meter uses LCD3 new version of communication protocol, it is compatible
LCD1 and LCD2.
1
Meter uses LCD1 and LCD2 old version communication protocol, it is not
compatible LCD3.
2
As data source for copying parameters, the meter transfers the new LD3
parameter to other meters.
C11 selects 2, hold
(SW) long for about 2 seconds to exit the setting
environment, and then the meter is served as data source for copying parameter (see
www.HalloMotor.com
