ELECTRIC BICYCLE METER — LCD3 Product User Manual
- 36 -
set values and enter C1 parameter setting interface again. Or hold
button
(SW)
long
for about 2 seconds to exit C parameter setting environment and return to the display 1.
○
Exit C Parameter Setting
Among the fourteen C parameter settings, when each parameter setting is completed,
if held
button (
SW
) long for about 2 seconds, all can exit the setting environment
and return to display 1, meanwhile, the current set parameters would be saved.
Under each parameter setting interface, if there’s no button operation on the meter for
more than 1 minute, and then the meter will automatically return to display 1, and the
original set parameters will be saved.
Parameter Copy
Set parameters (include general project parameter, P parameter and C parameter) of
all LCD3 meter produced by our company according to requirements , and set the meter to
be a data source according to the method of
"C11meter
attribute selection mode".
Use special wiring cables to properly wire to LCD3 meter needs to be copied
according to the diagram.
Meter parameter copy wiring diagram
www.HalloMotor.com
