1: Setup
2
000-10000-190-02-201511
Models Available
HL-3 Series light source models are available in regular (350 – 1100 nm or 350 – 1050 nm) and extended
(EXT models) (350 – 2400 nm) wavelength ranges. The INT models are used with an integrating sphere
(rather than a CC-3 cosine-corrected irradiance probe). The following models are available in the HL-3
Series:
Model
Calibrated Wavelength Range
Maximum
Uncertainty Level
Shutter?
HL-3-CAL
350
– 1100 nm
10%
No
HL-3-CAL-EXT
350
– 2400 nm
10%
No
HL-3-INT-CAL
350
– 1100 nm
15%
No
HL-3-INT-CAL-EXT
350
– 2400 nm
15%
No
In addition the following
plus
versions are available which reduce the percentage of uncertainty to 3%
and offer a shutter:
Model
Calibrated Wavelength Range
Maximum
Uncertainty Level
Shutter?
HL-3
plus
-CAL
350
– 1050 nm
3%
Yes
HL-3
plus
-CAL-EXT
350
– 2400 nm
3%
Yes
HL-3
plus
-INT-CAL
350
– 1050 nm
7%
Yes
HL-3
plus
-INT-CAL-EXT
350
– 2400 nm
7%
Yes
The following sections provide instructions on unpacking and setting up your HL-3 Series Light Source.
Unpacking the HL-3 Series Light Source
►
Procedure
1.
Unpack your lamp assembly and power supply carefully. Although the lamp is rigidly mounted,
dropping this instrument can cause permanent damage.
2.
Inspect the outside of the instrument and make sure that there is no damage. Do not use the
instrument if damage is present.
3.
Use this instrument in a clean laboratory environment (see
Contents
Your HL-3 Series Light Source package should contain the following:
