MAN1565-4
15
6.5
8 Way Switch and Indicator Card
This card has 8 switch inputs and 8 LED indicator outputs.
The switch inputs and LED outputs may be used in Cause and Effects.
The switches are configurable as either momentary or toggle switches. When configured as momentary pressing the
button once will cause an event to occur as programmed in C&E and the LED’s can be programmed to operate as an
output C&E effect.
When configured as toggle, pressing the button once will cause a condition to be held until the button is pressed
again. The associated LED is not available as an output in C&E and shall always be illuminated when the toggle
condition is active. Also, when configured as a toggle, there shall be an option for a timer override. If the toggle switch
is activated it shall be de-activated automatically after the timeout period.
Fit EOL Termination Link
if Last Module
on Comms Bus
In
Out
Address
Switch
Set to 1
1
2
3
4
ON
C
N
1
C
N
2
RS485 Control
/ 27VDC
Comms In
Top Card &
PCB Securing Clips
Bottom Card &
PCB Securing Clips
RS485 Control
/ 27VDC
Comms Out
Figure 9: 8 Way Switch and Indicator
