WWW.BESTHALO.COM | 4
JUMP STARTING YOUR VEHICLE WITH THE
HALO BOLT 57720
1. Plug the jumper cables into the jump start output on the
HALO BOLT.
NOTE:
Make sure the jumper cables are fully plugged into the jump start output before
trying to jump your vehicle.
2. Attach the jumper cable clamps to the vehicle battery.
- Red clamp on positive terminal (+)
- Black clamp on negative terminal (-)
NOTE:
Do not touch red (positive) and black (negative) clamps together at any point. If the
jump start button flashes red, the jumper cables have been connected incorrectly.
If this flashing red condition occurs, disconnect the jumper cables from the HALO
BOLT and vehicle battery and restart the process from step 1.
Positive Clamp
Negative Clamp
Positive Clamp
Negative Clamp
Summary of Contents for BOLT 57720
Page 1: ...OPERATING INSTRUCTIONS ...