HALO WATER SYSTEMS, LLC COPYRIGHT 2020 ALL RIGHTS RESERVED
H2 ZERO
®
Installation and Operation
ZERO ELECTRICITY • ZERO MAINTENANCE • ZERO WASTE
Whole House Filtration & Conditioning System
H2Z1054-CPI-100 H2Z1252-CPI-150
H2Z1054-CPSM-100
H2Z1252-CPSM-150
H 2 ZERO INTRODUCTION / INSTRUCTIONS BEFORE USING
1
Introduction
The
HALO
residential
H2 ZERO
®
systems provide protection
from hardness related to scale formation throughout the
plumbing system. The
H2 ZERO
®
system can be installed at
the point of entry to treat your entire home. These systems are
designed to treat the domestic water used in a single family
dwelling. For higher volume applications please contact your
HALO
representative.
H2 ZERO
®
prevents scale by transforming the normal dissolved
hardness minerals into undissolved crystal microparticles.
These crystals stay suspended in the water and have a reduced
ability to react and attach to surfaces. Therefore, the problem
of internal buildup of scale in pipes, water heaters and plumbing
fixtures is greatly reduced.
Unlike softened water,
H2 ZERO
®
treated water maintains the
beneficial essential mineral content of your water.
Read this Manual BEFORE using this equipment.
Failure to read and follow all safety and use information can result
in death, serious personal injury, property damage, or damage to
the equipment.
Keep this Manual for future reference.
The
HALO
H2 ZERO
®
system should be installed ONLY by a
licensed contractor.
FAILURE TO COMPLY WITH PROPER INSTALLATION AND
MAINTENANCE INSTRUCTIONS COULD RESULT IN PRODUCT
FAILURE WHICH CAN CAUSE PROPERTY DAMAGE,
PERSONAL INJURY AND/OR DEATH.
HALO Water Systems, LLC
is not responsible for damages resulting from improper installation
and/or maintenance. Local building or plumbing codes may require
modifications to the information provided. You are required to consult
the local building and plumbing codes prior to installation. If this
information is not consistent with local building or plumbing codes,
the local codes should be followed.
Refer to the enclosed for operating parameters to ensure proper use
with your water supply.
•
Use only lead-free solder and flux for sweat-solder connections,
as required by state, province and federal codes.
•
Handle all components of the system with care. Do not drop,
drag or turn components upside down.
•
Be sure the floor under the system is clean, level and strong
enough to support the unit.
•
Install the system in a protected area.
•
Do not attempt to treat water over 100°F with the system.
•
Always connect the system to the main water supply pipe before
the water heater.
•
Do not expose the system to freezing temperatures. Water
freezing in the system causes equipment damage.
WARNING
WARNING
Summary of Contents for H2zero
Page 1: ...OWNERS MANUAL INSTALLATION GUIDE...
Page 2: ......
