33
28
Upon a demand for Central Heating, (closur
e of the time clock
and room thermostat, where fitted), the controls should carry out
a set of start up checks, followed by an ignition sequence. Refer
to Section 5.2.
If the control has powered up correctly but does not respond to a
CH demand. Check voltage between pin 2 connector X1A
(orange wire) and pin 2 connector X1B (blue wire). If 0 V ac,
check room thermostat and clock. If 230 V ac, check control for
lockout or blocking codes, (refer to Diagnostics Chart), check
operation of the pump.
If room thermostat and clock are OK and no lockout or blocking
code exists and the control is not in anti cycle mode, then
everything should be working correctly, if not contact Halstead
Boilers Ltd Service Help Line: 01926 834834
Note:
Whenever a CH demand is removed,
either by the timer, the room thermostat or by the
appliance’s internal temperature control, an anti
cycle mode is initiated which prevents the
appliance from firing for 5 minutes. Ensure that
the control is not in this mode by removing power
from the control and restoring it after a delay of
10 seconds.
RESET LOCK-OUT CODES
LED CODE FAULT/EFFECT
REASON
ACTION
●
Check no air is in heat exchanger/CH system
1
Over
heated appliance
Water temperature greater than 105 °C
●
Check exter
nal diverter valve operation
●
Check pump operation
Differential check
●
Check flow/r
eturn thermister
faulty/Flame for
Zero check faulty CH
●
Check water pr
essure
2
●
Check pump/CH system blockage
15 seconds
●
Check no air is in heat exchanger/CH system
●
Check detection electr
ode/lead
●
Check gas supply
No gas or Lockout flame
Low gas pressure.
●
Check gas ser
vice cock
signal/ No flame, Lockout No flame signal on ignition,
●
Check gas valve and lead
3
after 5 ignition attempts
or loss of signal during operation
●
Check PCB/X2A & X2B connectors
●
Check spark generator/spark electr
ode
●
Check mains ear
th lead continuity
4
Flue gas sensor/No flame
Flue gas temperature greater than 95 °C
●
Check no air is in heat exchanger/CH system
water pressure
8.4
CENTRAL HEATING FAULT FINDING