Installation
Please make sure the Thingsee gateway device is installed before you
install the sensors.
To identify the sensor, read the QR code on the front of the device
with a QR code reader or Thingsee Toolbox application on your
mobile device.
Identifying the device is not necessary, but it will help you keep track of
your IoT installation and help Haltian support to solve possible issues.
Before installation, the sensor is in low power mode and the LED
indicator on the sensor blinks dimly every second. Note that with white
device casing, the LED blinking is difficult to see.
The sensor is switched on with the magnet switch tool by holding it
against the sensor’s magnetic switch.
D E V I C E
D E V I C E
E V E N T S
T O P O L O G Y
D E V I C E
D E V I C E
E V E N T S
T O P O L O G Y
ENVIRONMENT RUGGED
BIN VERSION:
3.4.37.0
SW VERSION:
2018.07.02.2_ts_pinsp34
BATT LEVEL: 100%
DESCRIPTION: Room1
TUID: TSENVYRUGGED042O02500875
I N F O
ENVIRONMENT RUGGED
16/11/2018 09:15:57
16/11/2018 09:14:57
16/11/2018 09:13:57
16/11/2018 09:12:57
16/11/2018 09:11:57
QR code
