17
Capture Jet
®
with Water Wash Operation & Maintenance Manual
OM-0
06/1
120
16/re
v2/EN
REPLACEMENT PARTS SCHEMATIC
Replacement Part Numbers
KSA Grease Extractor 13” X 20” – KSA13, 13” X 11” – KSA13-1/2
LED Light Base
10982
LED Light Lens
10848 Warm White 24 LEDs
10849 Cool White 24 LEDs
10979
Warm
White
12
LEDs
Water Wash Nozzle Information
Two different nozzles are supplied with the Capture Jet Water Wash Hood. Replacement nozzles are obtained from
Spraying Systems Co. Catalog number B5 nozzle washes the top of the grease plenum, the back of the KSA filters, the
front of the KSA grease filter, and make up a portion of the nozzles in the wash manifold that washes the inside of the
KSA grease filter. The B5 nozzles have an inlet connection size of 1/8”, orifice diameter 0.031”. The balance of the nozzles
which wash the inside of the KSA grease filter are Catalog number C30. The C30 nozzles have an inlet connection size of
1/8”, orifice diameter 0.023”. Maximum recommended water pressure is 80 psi, typical water pressure would be 40 psi.
PREVENTATIVE MAINTENANCE
Preventative maintenance is necessary for efficient operation of your Capture Jet ™ Water Wash hood.
Daily - Clean exhaust hood exterior. See cleaning exterior. Run the hood wash cycle.
Monthly - Inspect filters for grease accumulation and clean if required. Although this is listed as monthly, it may be
extended or shortened depending on the type of cooking and hours of operation.
Summary of Contents for Capture Jet KVC-WW
Page 11: ...11 Capture Jet with Water Wash Operation Maintenance Manual OM 006 112016 rev2 EN...
Page 12: ...12 Capture Jet with Water Wash Operation Maintenance Manual OM 006 112016 rev2 EN...
Page 19: ...19 Capture Jet with Water Wash Operation Maintenance Manual OM 006 112016 rev2 EN...
Page 26: ...26 Capture Jet with Water Wash Operation Maintenance Manual OM 006 112016 rev2 EN...
