2
Deutsch
Code scan Function
If programming using the direct codes failed to operate your TV, VCR or
Satellite then please use the automatic code scan which often finds compatible
codes from other brands or other models within your brand.
A. Switch on your TV SET. When scanning for a VCR code, switch on the
video recorder and start playing a videotape (i.e. start the play function on
the VCR).
B. Set the disk to position
and press the key on your remote control
(for approx. 4 seconds) until the LED flashes twice.
C. Enter code 1 1 1 1 (i.e. press
). The LED flashes twice.
D. Press and hold the
key until your TV SET is switched off. This
procedure might take up to 15 minutes (when searching for a VCR code,
press and hold the key and not the
key).
E. If the device responds by going into standby or the VCR tape stops then
immediately remove your finger from the relevant key and immediately
press the key, this will store the found code into the remote and the LED
flashes twice.
F. When using the Automatic mode it is possible that the remote will find
several codes that appear to work although these might not give 100%
compatibility. If this happens then restart the Automatic mode and move
onto the next code. Please be patient as it might be necessary to scan
through many different codes until a suitable one is found.
Code scan for VCR or SAT
To complete a code scan for VCR or SAT, proceed as described for a TV code
scan. Set disk to position
or
respectively and complete the above
steps A to F.
At step D, press the
key for SAT and the key for VCR.
Reading of currently set code
If you have programmed your remote control by means of a code scan, or if
you do not remember the code you have entered, you have the option to read
the currently used code.
A. Set the disk to position
and press the key on your remote control
(for approx. 4 seconds) until the LED flashes twice.
B. Enter code 1 1 1 2 (i.e. press
). The LED flashes twice.
C. Press the key and count the number of LED flashes. This number
corresponds to the first digit of the code.
D. Press the key and count the number of LED flashes. This number
corresponds to the second digit of the code.
E. Press the key and count the number of LED flashes. This number
corresponds to the third digit of the code.
F. Press the key and count the number of LED flashes. This number
corresponds to the fourth digit of the code.
G. Steps C, D, E and F can be repeated as often as necessary.
To read the currently used VCR or SAT code, proceed as described above for
your TV SET. Set disk to position
or
respectively and complete the
above steps A to G.
Write down the code number as indicated by the LED.
SAT
VCR
▲
OK
▲
▲
▲
▲
▲
▲
F
TV
SAT
VCR
F
▲
▲
▲
▲
F
TV
USER MANUAL
GB
